Hitachi WJ200 VFD
Last updated
Was this helpful?
Woodworking
Last updated
Was this helpful?
The following settings were provided by UGRA CNC. These are the last good known setting for the VFD. In most cases, you should not need to change these settings.
If any of the firmware setting was changed and the spindle no longer operates, you may need to do a factory reset and manually enter the settings below.
B037
0
Unlock parameters
A001
2
Frequency source Set to 1 to enable potentiometer
A002
2
Run command source
A004
400
Max frequency
A003
400
Base frequency
A082
220
AVR voltage
A044
3
Set Sensorless Vector Control Will not work with 2 motors per drive
B012
Set equal to motor amperage
H002
2
Motor constant selection
H003
2.2
Motor capacity
H004
2
Poles setting
H001
2 -> Run
Run spindle. Auto detection ___ should appear when successful
B083
Increase value in case of weird sound. Read manual.
F001
400
Control spindle speed by setting this parameter. Can be changed while spindle is on.